引用本文:周永涛,王汉功,胡重庆,姚春江.超音速电弧喷涂Ti-Al涂层耐磨性及工艺研究[J].中国表面工程,2004,(5):41~44
.Research on Wear-resistance of Ti-Al Coating Produced by Supersonic Arc Spraying[J].China Surface Engineering,2004,(5):41~44
【打印本页】   【HTML】   【下载PDF全文】   【查看/发表评论】  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被：浏览 4313次   下载 83次 本文二维码信息
码上扫一扫！
分享到： 微信 更多
字体:加大+|默认|缩小-
超音速电弧喷涂Ti-Al涂层耐磨性及工艺研究
周永涛,王汉功,胡重庆,姚春江
作者单位
摘要:
基于均匀设计试验设计方法，进行了超音速电弧喷涂Ti-A1涂层磨粒磨损试验，在对试验结果进行逐次回归分析的基础上，系统并定量的研究了涂层耐磨性能随着喷涂工艺参数的变化规律，得到了优化后的最佳喷涂工艺参数。
关键词:  超音速电弧喷涂 Ti—Al涂层 磨粒磨损 均匀设计 逐次回归
DOI：
分类号:TG174.442
基金项目:
Research on Wear-resistance of Ti-Al Coating Produced by Supersonic Arc Spraying
ZHOU Yong-tao  WANG Han-gong  HU Chong-qing  YAO Chun-jiang
Abstract:
In this paper, based on the uniform design principle, an abrasive wear test of Ti-Al coating produced by supersonic arc spraying was conducted, and a stepwise regression analysis was made. The changing rule of coating wear-resistance with spraying parameters was studied systematically and quantitatively. The optimum spraying parameters were obtained finally.
Key words:  supersonic arc spraying,Ti-Al coating,abrasive wear,uniform design,stepwise regression
手机扫一扫看