引用本文:胡军志,马世宁,陈学荣.热电厂用高速电弧喷涂FeCrAl/WC涂层的性能研究[J].中国表面工程,2003,(1):1~3,12
.An Investigation on Performances of High Speed Arc Spraying FeCrAl/WC Coating for Power Plant[J].China Surface Engineering,2003,(1):1~3,12
【打印本页】   【HTML】   【下载PDF全文】   【查看/发表评论】  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被：浏览 4775次   下载 107次 本文二维码信息
码上扫一扫！
分享到： 微信 更多
字体:加大+|默认|缩小-
热电厂用高速电弧喷涂FeCrAl/WC涂层的性能研究
胡军志,马世宁,陈学荣
作者单位
摘要:
利用高速电弧喷涂技术将自行研制的FeCrAl/WC粉芯丝材制备出FeCrAl/WC复合涂层。采用EDS谱、XRD谱和成分分析系统测到FeCrAl/WC涂层的组成为84％FeCr 16％(WC、W2C、少量(FeCr)2O3和Al2O3)。通过对涂层的显微组织和力学性能的研究，得出FeCrAl/WC复合涂层的组织呈现出典型的层状结构特征；涂层综合力学性能优异，具有较高结合强度、高致密度、较佳的耐热震性能等特点。结果表明，该涂层在所测的力学性能方面能适用于热电厂燃煤锅炉管道的服役条件，能够满足实际工况应用的需要。
关键词:  高速电弧喷涂 复合涂层 显微组织 力学性能
DOI：
分类号:TG174.44
基金项目:
An Investigation on Performances of High Speed Arc Spraying FeCrAl/WC Coating for Power Plant
HU Jun-zhi  MA Shi-ning  CHEN Xue-rong
Abstract:
A composite FeCrAl/WC coating produced by high speed arc spraying and welding wire with powder filling inside was successfully developed. The composition of this coating was identified by EDX and XRD as 84 % FeCr+16 % (WC, W2C) and trace (FeCr)2O3 and Al2O3. This FeCrAl/WC composite coating displayed the typical layered structure characteristic, excellent comprehensive mechanical properties, higher bonding strength with substrate, good fineness and thermal shock-resistance. The results of investigations, showed that this coating can be used for the boiler-tubes of power plant and can satisfy the necessity of practicle working conditions.
Key words:  high speed arc spraying,composite coating,microstructure,mechanical properties
手机扫一扫看